Controll-A-Door P Diamond Instruction Manual download pdf (Page 12)

Step 7.1 - Setting Travel Limits

NOTE: If Infra-red Safety Beams are to be used they must be

installed before setting the travel limits.

WARNING! Use caution when operating the

manual release with the door open since it

may fall rapidly due to weak or broken springs,

or an improperly balanced door.

CAUTION! Do not disengage the opener to

manual operation with children, persons or

any objects including motor vehicles within

the doorway.

Move the door to half way open. If necessary, disengage

the opener by pulling the red handle down.

Re-engage the opener by pulling the red handle down.

Turn on the power to the opener. The CLOSE LIMIT

LED will be flashing.

Press and hold the MINUS (-) button - the door should

starting closing (Fig. 12).

If the door opens, release the MINUS (-) button

and press the OPERATE button once to change

the motor’s direction. Press the MINUS (-) button

again to close the door.

Release the MINUS (-) button when the door is near the

desired closed position. Single presses of the MINUS

(-) button will “inch” the door closed.

If the door overshoots press the PLUS (+) button to

move the door in the open direction.

When the door is at the desired close position, press

the LIMIT SET button to record the Close limit position.

The OPEN LIMIT LED will now flash.

Press and hold the PLUS (+) button to open the door

Release the PLUS (+) button when the door is near the

desired open position. Single presses of the PLUS (+)

button will “inch” the door open.

If the door overshoots press the MINUS (-) button

to move the door in the open direction.

WARNING! Once the next step is performed,

the door will automatically close and open.

Keep persons and objects clear of the door

until it stops and the opener sounds a beep.

Press the LIMIT SET button to store the open limit.

Please read the above warning.

Step 7.2 - Resetting Travel Limits

To reset the limits press and hold the LIMIT SET button for 6

seconds until the Close Limit LED flashes quickly. If no action

is taken within 30 seconds, the opener will return to normal

operating mode and restore the original limit settings

Setting Travel Limits

Fig.12

Controll-A-Door

Diamond PD - Power Drive Instruction Manual12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

Comments to this Manuals

No comments

Controll-A-Door P Diamond Instruction Manual Page 12

Comments to this Manuals