Controll-A-Door P Diamond Instruction Manual download pdf (Page 17)

Diamond PD Power Drive : Instruction Manual

17Controll-A-Door

Diamond PD - Power Drive Instruction Manual

Safety Infra-red B eam (Part No 062734)

For

ADDITIONAL PR OTE CTION

B&D Doors

STRONGLY

recommend the fitting of a Safety Infra-red B eam. In most

countries Safety Infra-red Beams are mandatory on all garage

doors fitted with automatic openers. For a small additional

outlay, B &D recommends that Safety Infra-red Beams be

installed with the automatic opener ensuring additional

safety and peace of mind.

IMPORTANT NOTE: The S afety Infra-red

Beam must be installed and connected before

the travel limits are set - See Step 7.

WARNING:

Doors requiring over 400N of force

dett if smaeB der-arfnI yetfaS evah tsum evom ot

for safety.

Locate the Safety Infra-red Beam in a strategic location within

the doorway. It is recommended that it be positioned

level roo lf eht evoba mm051

as close as possible to the door opening

inside the garage

Make sure to align the beams correctly. Follow the manual

supplied with the Safety Infra-red B eams. Connect the wires

to the terminal blocks as per (Fig.24).

WARNING:

When using Auto-Close mode and

Safety Infra-red Beams, the doorway must be

clear of all obstructions and persons at all times.

The location of the beam and manner in which it

is installed might not give safety protection at all

times. Check to make sure that the height of the

beam and type used give maximum protection

possible.

WARNING:

Automatic door - The door may

operate unexpectedly, therefore do not allow

anything to stay in the path of the door.

CAUTION! The location of the beam and

manner in which it is installed might not give

safety protection at all times. Check to make

sure that the height of the beam and type used

give maximum protection possible.

Electric Key Switch (Part No 062738)

An electric key switch provides an alternative to using a

transmitter. Each key turn cycles through an open/stop/

close function. The electric key switch is also an external

release mechanism - ideal for garages only one entrance.

To connect the switch to the opener’s terminal block J2 refer

to (Fig.25) and the E lectric K ey Switch's instruction sheet.

•

Accessories

Fig.24

Fig.25

24V

12V

24V

12V

1 2

3 4 5

30V PWR

PE (IR)

PE(0V) (IR(0V))

WIRE COLOUR: R-Red, B-Black, Y-Yellow.

NOTE: Resistor R1 shall be 2.2kOhm, 1/4W

CABLE 1

CABLE 2

RECEIVER

TRANSMITTER

30V PWR

PE(IR)

PE(0V)(IR(0V))

GND

OPERATE

AUX OUT

Model: PE-2

R 1

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

Comments to this Manuals

No comments

Controll-A-Door P Diamond Instruction Manual Page 17

Comments to this Manuals